Psion EP10 Manuel d'utilisateur télécharger pdf (Page 55)

Chapter 3: Getting to Know the EP10

Audio Indicators

Psion EP10 Hand-Held Computer User Manual

Keep in mind that the application running on the EP10 can dictate how the application LED operates.

Review the documentation provided with your application to determine LED behaviour.

If the EP10 is attached to an external power supply, the charge LED (the left-most LED) reflects the battery

charge status.

3.6 Audio Indicators

The audio speaker provides a variety of sounds when a key is pressed, a keyboard character is rejected,

scan input is accepted or rejected, an operator’s entry does not match in a match field or the battery is low.

To specify how you want your EP10 to respond under various conditions, refer to“Sounds Tab” on page 107.

3.6.1 Vibration Settings

You can set the EP10 to Vibrate or Vibrate and Ring when you receive an incoming phone call. Refer to “No-

tifications Tab” on page 107 for details about choosing Events and Ring types.

3.6.2 Adjusting Speaker Volume

The Volume button is located on the left side of the EP10, just above the Scan button. It is a rocker button;

pressing the top half of the button increases volume while pressing the bottom half of the button

decreases it.

Table 3.1 Function of EP10 LEDs

LED Function

Green Charge LED

(left-most LED)

Charge indicator. See the table below for descriptions of Charge LED

behaviour.

Yellow Application LED (centre

LED)

Application LED. The behaviour of this LED is application dependent.

Blue Radio Power LED (right-

most LED)

Radio power indicator.

Table 3.2 EP10 Charge LED Behaviour

Charging Status LED Colour LED Flash Rate Duty Cycle

No external power detected. Not applicable OFF Not applicable

Battery charge complete. GREEN Solid ON Continuous

Battery charging normally. GREEN Slow Regular

Battery not charging because battery

temperature is outside the allowable

range: 0° C to 40° C, 32° to 104° F.

YELLOW Normal Regular

Battery charge failure. Unable to read

battery or non Psion battery.

RED Solid ON Continuous

Note: When the Power button is pressed, the yellow LED will flash to let you know that the hand-

held is powered up. At this point, you can go ahead and release the Power button.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 265 266

Commentaires sur ces manuels

Pas de commentaire

Psion EP10 Manuel d'utilisateur Page 55

Commentaires sur ces manuels