Psion EP10 Manuel d'utilisateur télécharger pdf (Page 196)

Chapter 7: Peripheral Devices & Accessories

Chargers and Docking Stations

Psion EP10 Hand-Held Computer User Manual

182

7.3 Chargers and Docking Stations

Psion offers a variety of chargers and docking stations for the EP10. These include:

• Snap Modules are mobile adaptors designed for the EP10. Two models are available: Charger Snap

Module with USB and DC, Model RV4001 and Charger Snap Module with RS-232 and DC, Model

RV4002.

• AC Adaptor – Model PS1050 - G1 is used to power both snap module variants

• AC Adaptor – Model RV3055 is used to power the following docking stations and chargers: desktop

docking station, quad docking station and quad charger.

• Vehicle Power Outlet Adaptor – Model RV3050

• Desktop Docking Station – Model RV4000

• Quad Docking Station – Model RV4004

• Quad Charger – Model RV3004

7.3.1 Important Safety Instructions

• Before using the AC adaptor, Desktop Docking Station, Quad Charger, or Quad Docking Station, read all

instructions and markings on the housing.

• Use the AC adaptor, batteries, and other attachments recommended or sold by Psion.

• The mains power cord (sold separately) shall comply with the national safety regulations of the

country where the equipment is to be used.

• These docking stations cannot be used with non-EP10 PDAs. Although they may share the same

battery terminating connector, they are designed with different applications in mind.

• Do not operate the AC adaptor with a damaged cord or plug. Replace immediately.

• Do not disassemble the AC adaptor; it should be repaired by qualified service personnel. Incorrect

reassembly may result in electric shock or fire.

• To reduce the risk of damage to the electric plug and cord when unplugging a docking station, pull the

plug rather than the cord.

• Make sure the cord is positioned so that it is not stepped on, tripped over, or otherwise subjected to

damage or stress.

• Do not operate the AC adaptor, the RV4000, or the RV4004, if it is struck by a sharp blow, dropped, or

otherwise damaged in any way; it should be inspected by qualified service personnel.

• To reduce the risk of electric shock, unplug the AC adaptor from the outlet before attempting any

maintenance or cleaning.

• An extension cord should not be used unless absolutely necessary. Use of an improper extension cord

could result in fire or electric shock. If an extension cord must be used, make sure:

- The plug pins on the extension cord are the same number, size, and shape as those on the adaptor.

- The extension cord is properly wired and in good electrical condition, and that the wire size is larger

than 18 AWG.

• Do not expose the AC adaptor to rain or snow. However, both the RV4000 and RV4004 are designed

to accept a wet EP10 hand-held without harmful effect.

• Do not place batteries in the docking stations if they are cold—temperatures below 0°C (32°F). Allow

them to warm up to room temperature for at least 30 minutes.

• Do not use a docking station if, after an overnight charge, the battery feels warmer than the charger

housing. The dock should be inspected by qualified service personnel.

• Do not use a docking station if the battery, while charging, becomes more than lukewarm.

Note: For information about inserting, removing and charging the battery, refer to “The Battery”

on page 32. For battery specifications, refer to “Lithium-Ion 3600 mAh Battery Specifica-

tions” on page 208.

Important: Keep in mind when ordering a charger or docking station that you must also order

the country-compatible power cord separately.

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 265 266

Commentaires sur ces manuels

Pas de commentaire

Psion EP10 Manuel d'utilisateur Page 196

Commentaires sur ces manuels