Psion EP10 Manuel d'utilisateur Page 207

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 266
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 206
Chapter 7: Peripheral Devices & Accessories
The Powered Vehicle Cradle – Model No. RV1005
193
Psion EP10 Hand-Held Computer User Manual
cradle. The cradle design permits access for the DC input cable to connect to the EP10. The cradle is also
equipped with an RS-232 port (no power on pin 9), a micro-USB AB port and a DC jack connector.
The cradle comes with four mounting screws, with illustrated electrical and mounting instructions.
Before Psion releases a product, our engineering team exposes that product to a series of severe testing to
ensure that it will survive in the rugged environments in which our products are typically used. These tests
usually include shock and vibration testing as well as IP testing for water and dust, electrical shock, etc.
If a third party vehicle mount is used, the third party should perform the same type of testing in order to
ensure that the design will maintain the factory specifications of the product. If the third party company is
unwilling to perform the necessary testing and take responsibility for the effects of the design, then we
highly recommend using Psion designed and supported accessories.
If you elect to use a third party company produced cradle, Psion cannot take responsibility for the effects of
that third party product if it causes failure of our device.
Figure 7.8 RV1005 Powered Vehicle Cradle
Important: Before using a vehicle cradle, read all instructions and markings on the housing.
Do not operate a vehicle cradle if damaged by a sharp blow, dropped, or otherwise
damaged in any way; qualified service personnel should inspect for internal
damage.
Shock and vibration specifications for the EP10 are verified using Psion-approved
RAM
®
mounts and mounting hardware. Use of non-certified Psion mounting hard-
ware is not recommended, and may void warranty coverage.
Do not expose to rain or snow! However, the Powered Vehicle Cradle is designed to
accept a wet EP10 handheld without harmful effect.
This Powered Vehicle Cradle cannot be used with non- EP10 cradle accessories.
Place Holder
Vue de la page 206
1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 265 266

Commentaires sur ces manuels

Pas de commentaire