Psion EP10 Manuel d'utilisateur télécharger pdf (Page 203)

Chapter 7: Peripheral Devices & Accessories

Operator Controls

189

Psion EP10 Hand-Held Computer User Manual

The charger can consume up to 1.5 A at 100-240 VAC. Check to ensure the mains circuit supplying the

charger is adequate for this loading (especially if several chargers are being powered from the same cir-

cuit). After unpacking the unit:

• Visually check the charger for damage.

• Install the IEC power cord and apply power.

All charge indicators flash momentarily at power up to indicate that the charger is ready for operation.

7.7. 3 O p e ra to r Co n t ro l s

The gang charger does not have operator controls or a power switch. There is no dedicated indicator light

to show that the charger is powered, but the charge slot LEDs will light.

7.7. 4 Ch a r g e I nd i c a to r s

Each battery charge slot is equipped with four LEDs to indicate the charge status of the battery. When the

EP10 batteries are inserted in the charger, the colour and behaviour of the LEDs associated with the charge

wells in use indicate the status of the charge.

Table 7.1 Charge Status Indicator LEDs

7.7. 5 C h a r g i n g B a t te r i e s

• Slide an EP10 battery, as shown, into each charge compartment until the battery touches the base of

the charge compartment. Ensure that the contacts on the battery meet the contacts in the battery

charge bay.

The 4-LED bar for the battery bay shows 25% charger per LED. A flashing green LED shows charging is

under way. The LED directly below the slot in which a battery is inserted lights up immediately. If the

battery temperature is outside 0° C and 40° C (32° F to 104° F), the LED flashes yellow until the tempera-

ture is acceptable. A fully discharged battery will normally take from 3 to 4 hours to charge. At full capacity,

it turns solid green.

When the battery is fully charged, the charger stops applying power; the battery cannot be overcharged if

left in the charger slot.

Important: Use IEC-320 C13 power cords approved by Psion, with the ground pin connected

to a proper earth-grounded receptacle. Check with a qualified electrician if you are

uncertain of your receptacle grounding.

Important: If you choose to wall mount the charger, detailed installation instructions are

included in the ‘EP10 RV3004 Charger Spare Battery 4 Slot Quick Start Guide’

(PN 8000233) included with the quad charger. Be sure to locate the charger in an

area where there is no risk of injury to persons walking in the vicinity.

Charge LED Behaviour Function

OFF No battery detected.

Solid Green Battery charging complete.

Flashing Green Charge in progress.

Flashing Yellow Battery is not charging due to out-of-temperature conditions.

Solid Red Unable to read battery or non Psion battery.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 265 266

Pas de commentaire

Psion EP10 Manuel d'utilisateur Page 203