Psion EP10 Manuel d'utilisateur télécharger pdf (Page 23)

Chapter : Getting Started

Preparing the EP10 for Operation

Psion EP10 Hand-Held Computer User Manual

2.1 Preparing the EP10 for Operation

2.1.1 The Batteries - 2400 mAh and 3600 mAh Lithium Ion

Two Lithium-Ion battery pack variants are available for the EP10: High Capacity 3600 mAh battery pack,

Model Number RV3010 and Standard Capacity 2400 mAh battery pack, Model Number RV3005.

Before charging the battery, it is critical that you review the battery safety guidelines in the “EP10

Hand-Held Warranty & Regulatory Guide”, PN 8000235.

Battery packs shipped from the factory are charged to approximately 40% and must be fully charged prior

to use. Batteries can be charged using a variety of chargers and docking stations along with an EP10 inter-

nal charger. When using the internal charger, a suitable power source is required. All chargers and docking

stations are described in Chapter 7: “Peripheral Devices & Accessories”.

2.1.2 Installing the Battery

• Match the contacts at the bottom of the battery with those in the battery well of the EP10 hand-held,

and gently snap into place.

2.1.3 Removing the Battery

• Slide the battery release button (located just above the battery) to the right to release and remove the

battery from the unit.

2.1.4 Switching the EP10 Hand-Held On

• Press and release the Power button.

The centre LED flashes yellow and the desktop To day screen is displayed.

2.1.5 Switching the EP10 Hand-Held Off

• Press and release the Power button.

2.2 Data Transfer Between the PC & the EP10

Important: Always switch the unit off before changing the battery (see “Switching the EP10

Hand-Held Off” on page 9). If you do not turn the hand-held off before removing

the battery, it may be necessary to reboot the unit. Any active sessions may

be lost.

Note: If the EP10 was already in use, pressing the Power button ‘wakes’ it from suspend. The screen

in which you were working prior to the suspend state is displayed.

Important: If your EP10 fails to power up, consider the following troubleshooting options: the

battery capacity may be lower than the suspend threshold, it may be

overheated (>60° C), or the battery may have fallen below the configured

suspend threshold. Refer to Section 6.5.5 Suspend Threshold and Estimated

Battery Backup on page 106 for additional details about this setting.

If you provide AC power to the EP10 and either the battery capacity is too low or is

overheated, a yellow LED will flash and the unit will not

switch on. To switch on the

hand-held, replace the overheated battery or, in the case of a depleted battery, wait

for the capacity to reach an acceptable level.

However, if you provide AC power to an EP10 with a battery that falls below the

configured suspend threshold, the hand-held will

switch on provided the battery

capacity is above 0 mAh.

Note: For details about connecting your EP10 to a PC using a docking station, refer to “Linking an

EP10 to a PC” on page 185.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 265 266

Commentaires sur ces manuels

Pas de commentaire

Psion EP10 Manuel d'utilisateur Page 23

Commentaires sur ces manuels