Psion EP10 Manuel d'utilisateur télécharger pdf (Page 199)

Chapter 7: Peripheral Devices & Accessories

Cleaning the RV4000

185

Psion EP10 Hand-Held Computer User Manual

7.5 .2 . 2 Ch a r g i n g a S pa re B a tt e r y

• Insert the spare battery in the charge well at the back of the RV4000, aligning the contacts on the

battery with the contacts in the spare battery charge well.

A full charge takes between 3 and 4 hours for the battery.

When the battery capacity reaches 95%, the LED turns solid green and remains in this state once the

battery is completely charged.

7.5.2.3 Linking an EP10 to a PC

The desktop docking station can be connected to a PC so that you can exchange files in the same way that

you would between PC drives. A USB cable is included with your docking station.

To link the EP10 to a PC:

• Insert the EP10 in the desktop docking station.

• Insert the micro USB connector into the docking station. Attach the other end of the cable to a USB

port on the PC.

7.5.3 Cleaning the RV4000

• Use only mild detergent or soapy water on a slightly damp cloth to clean the RV4000. Avoid abrasive

cleaners, solvents or strong chemicals for cleaning. The plastic case is susceptible to harsh chemicals.

It is partially soluble in oils, mineral spirits and gasoline and slowly decomposes in strong alkaline

solutions.

• To clean ink marks from the label, use isopropyl alcohol.

7.5.4 Troubleshooting

7.5.4.1 Docking Station does not Power On

• When first connected to the DC power supply, the spare charger LED should turn ON and remain on for

3 seconds. If this does not occur, the charger is defective and requires service.

7.5.4.2 EP10 Charge LED Stays Off

When an EP10 is docked into a powered RV4000 and the EP10 charge indicator LED stays off, there may be

a problem with the unit or with the docking station. Use an EP10 with a properly functioning charge indica-

tor to isolate the problem.

7.5.4.3 EP10 Charge LED Flashes Yellow

A flashing yellow EP10 charge LED (the left-most LED on the hand-held) indicates that the battery is not

within the charging temperature range — 0° C and 40° C (32° F to 104° F). Allow the battery to come to an

acceptable range before reinserting the EP10 in the docking station.

7.5.4.4 Dock Battery LED Fast Flashes Red with Spare Battery Inserted

• Your Psion battery and desktop docking station are carefully designed for safety and capacity perform-

ance in accordance with IEEE 1725. If the battery or charger are not Psion approved products, or the

safety mechanism is faulty, the spare charge slot LED or EP10 LED will display solid red.

• Try inserting a battery that has been tested in another charger and is known to work.

Note: Do not store a spare battery in a charger for more than 72 hours. Doing so may damage the

battery or reduce its charge capacity.

Note: For details about data transfer through Windows XP and ActiveSync and through Vista and

Windows 7, refer to “Data Transfer Between the PC & the EP10” on page 9.

Important: Do not immerse the unit in water. Dampen a soft cloth with mild detergent to wipe

the unit clean.

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 265 266

Commentaires sur ces manuels

Pas de commentaire

Psion EP10 Manuel d'utilisateur Page 199

Commentaires sur ces manuels