Psion EP10 Manuel d'utilisateur télécharger pdf (Page 26)

Chapter : Getting Started

Wi -Fi Config: Configure Tab

Psion EP10 Hand-Held Computer User Manual

Connect: Used to connect to an already existing wireless network configuration.

Add New: Used to create a new wireless network configuration.

Edit: Used to change values in an existing wireless network configuration.

Remove: Used to delete a wireless network configuration.

Scan: Used to detect and list available wireless networks. You can highlight a network in the list, and

tap on Add New to activate the network.

There are two methods available when configuring a radio network – you can either scan for an existing

network or manually create a network. If you tap on the Scan button, a list of networks detected by the

radio is displayed. Highlighting one of the listed networks and tapping on the Add New button creates a new

profile that is completed based on the security capabilities detected by the radio. You may need to add ad-

ditional information, depending on your network requirements.

If you tap on the Add New button rather than the Scan button, you can create a network manually.

2.5.2.1 Manually Creating a Network

•In the Configure tab, tap on the Add New button.

• Enter the SSID (Service Set Identifier) for your network.

Important: The steps below describe how to manually create a network. Keep in mind that this

is intended only as an example

and may vary from your own network requirements.

If, for example, you are using a different type of security for your network, the

fields you complete may not match those described here.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 265 266

Pas de commentaire

Psion EP10 Manuel d'utilisateur Page 26