Psion OMNII Manuel d'utilisateur Page 340

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 358
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 339
D-34 Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
Appendix D: Teklogix Imagers Applet
Bar Code Symbologies – Descriptions
Discrete 2 of 5
Minimum and Maximum Length
The length of a code refers to the number of characters (i.e., human readable characters), in-
cluding check digit(s). Double-tapping on these parameters displays a screen in which you
can set the minimum and maximum allowable code lengths – 1 to 48.
D.5.17 Discrete 2 of 5
Enabled
Set this parameter to on to enable “Discrete 2 of 5”.
Minimum and Maximum Length
The length of a code refers to the number of characters (i.e., human readable characters), in-
cluding check digit(s). Double-tapping on these parameters displays a screen in which you
can set the minimum and maximum allowable code lengths – 1 to 48.
D.5.18 Telepen
Enabled
Set this parameter to on to enable “Telepen”.
Enable AIM Output
If you set Enable AIM Output to on, the imager reads symbols with start/stop pattern 1 and
decodes them as standard full ASCII (start/stop pattern 1). If you set this parameter to off,
the imager reads symbols with start/stop pattern 1 and decodes them as compressed numeric
with optional full ASCII (start/stop pattern 2).
Minimum and Maximum Length
The length of a code refers to the number of characters (i.e., human readable characters), in-
cluding check digit(s). Double-tapping on these parameters displays a screen in which you
can set the minimum and maximum allowable code lengths – 1 to 60.
D.5.19 GS1 DataBar
GS1 DataBar
Set this parameter to on to enable the imager to read “GS1 Databar” symbols.
Vue de la page 339
1 2 ... 335 336 337 338 339 340 341 342 343 344 345 ... 357 358

Commentaires sur ces manuels

Pas de commentaire